Benelli TORNADO NAKED TRE R160 User Manual

MAINTENANCE
88
6 • MAINTENANCE
6.14 Prolonged inactivity
If the motorcycle is not to be used for a long period, contact a Benelli Q.J. authorized service center to have the following
operations carried out:
- Empty the fuel tank.
- Remove the battery and store it in a suitable place.
- Remove the spark plug caps and the spark plugs.
Pour a teaspoonful of engine oil in every spark plug hole, thenplace back the spark plugs and the corresponding caps. Make the
engine run idle for a few times.
- Lubricate all control cables and the joints of all pedals and levers.
- Clean the motorcycle and treat the paintwork with high quality wax.
- Park your motorcycle in a fresh, dry and dark place, with a temperature relatively constant and lower than 25° C(77°F).
Avoid direct contact of the tyres with heating pipes or radiators, and prolonged contact with oil or gasoline.Avoid parking with the
tyres near to electrical motors or devices capable to produce sparks or electric discharge. During the period of inactivity, place your
motorcycle on the rear stand.
- Cover the vehicle with an adequate canvas cover Benelli Q.J. that can be bought as optional.
When the motorcycle is used the first time, carry out a general check and have it serviced at anauthorized
service center.

Benelli TORNADO NAKED TRE R160 Specifications

General

Gearbox	6-speed
Final Drive	Chain
Compression Ratio	12.5:1
Starting System	Electric
Clutch	Wet multi-plate
Front Tire	120/70-ZR17
Rear Tire	190/50-ZR17
Max Power	157.8 hp @ 10, 200 rpm
Max Torque	120 Nm @ 8, 400 rpm
Fuel System	Electronic fuel injection
Front Suspension	Upside-down telescopic fork
Front Brake	2 x 320 mm floating discs, Brembo radial calipers
Rear Brake	Single disc, 220 mm
Weight	205 kg (452 lbs)
Bore x Stroke	88 mm x 62 mm
Frame Type	Steel trellis
Length x Width x Height	790 mm
Wheelbase	1443 mm