Benetech GM3125 - Continuous Measurement; Timer Measurement

TIMER
SET
-17- -18-
3. Remove the test wires firstly, then set the function switch
to OFF position.
Continuous measurement
1. About the first and second procedure, please refer to
INSULATION RESISTANCE MEASUREMENT.
2. Connect the test pin/clip to the unit tested. Press and
Rotate the PRESS TO TEST button clockwise to perform
a continuous measurement. The buzzer will sound at this
time. LCD display as below:
After measurement, rotate the test button original position in
anticlockwise, The instrument will discharge the high voltage
automatically, the high voltage light and sounds will stop.
Remove the test wires only when LCD display 0V, LCD
display as below:
Timer measurement
This is a function to conduct a test automatically at any
set time.
1.
2. Press the “ ” button and TIME1 mark will be
displayed.
3. Press or button to set up times, for example,
30 second. LCD display as below:
About the first and second procedure, please refer to
INSULATION RESISTANCE MEASUREMENT.
4.Press and rotate the PRESS TO TEST button clockwise
to perform a timer measurement of insulation resistance,
the buzzer will sound and the “ ” will flash, LCD
display as below: