Beninca BE.CODE - MENU 8; MENU 9; TO MEMORISE THE FATHER CODES IN THE RECEIVER; COMPLETE MEMORY RESET

14
ifaRolling-Codeisdesired.
- Type2>(2beeps)
ifanAdvancedrollingcode(ARC)isdesired.
- Type3>(2beeps)
if a Fixed Code is desired.
MENU 8
To check the coding type
Ifallowstocheckthetypeofradiocodingre-
latedtoadeterminedcodestoredinmemory.
Aftertypingkey 8,two beepsfollowedby an
intervalareheard.Thesystemiswaiting for
the code.
- Typethe code to be checked followed by
ENTER.
If the code is memorised, BE.CODE replies with
1, 2 or 3 beeps:
- Rolling-code:1beep
- Advancedrollingcode(ARC):2beeps
- Fixed Code: 3 beeps
MENU 9
Code repetition activation with ENTER
Throughthisfunctionitispossibletoenablethe
button,ENTERascode“repeater”,duringthe
20 seconds following the code introduction.
This function might be useful to
check the automatic systems preset
withStep-by-Stepcycleoperation(e.g.
OPEN>STOP>CLOSE>STOP>OPEN>).
After20seconds,thesystemexitstherepeti-
tionmodeandanewvalidcodeshallbetyped
in again.
Inthe factory conguration this function is
disabled.
Aftertypingkey9,twobeepsfollowedbyan
intervalare heard. The system enters a wait
state.
- Typein1
if the function is to be activated.
- Typein0
if the function is to be deactivated.
Then,three beeps are heard followed by an
interval.Thedeviceactivatesordeactivatesthe
function and exits the programming mode.
TO MEMORISE THE FATHER CODES IN
THE RECEIVER
After programming the father/child codes as
required, the father codes must be stored in
thereceivermemory.
Proceed according to instructions given with
the receiver.
When the receiver enter the wait state for a
codetobememorised,digittheFATEHRcode
(oraChildcodematchedwithit),pressENTER
and BE.CODE will send the code to be stored
inthereceivermemory.
More than one receiver can be used, also
with a different decoding, and in the event of
multi-channel receivers, various codes can be
matched to various channels.
Intheeventofespeciallycomplexinstallations,
itis advisable to make and carefully keep a
diagram of the various receivers used, as well
as their functions and related BE.CODE codes
matched to it.
COMPLETE MEMORY RESET
1Removebattery(ifinserted).
2 Press Enter
3Replacethebatteryandwaitfordeviceini-
tialization(5beepbeep-pause-2)
4Now type in the memory reset password
“1234567890”,followedbyEnter.
5 An intermittent buzz can be heard to indicate
thatthememoryhasbeenerased.
Thereset restored the factorypresetting.All
customized codes and settings are removed.
DISPOSAL
When the product is out of order, it must be
disposed according to regulations in force on
wastedisposalandrecyclingofthe various
components(metal,plastics,electricalwires,
etc.).Forthispurpose,itisadvisabletocontact
yourinstalleroraspecialisedcompany.