8.
SETTING UP YOUR HYDRO 15 FOR DRY VACUUMING:
11. Unwind the power cable and plug it into the wall socket
12. Switch on the unit using the power switch (1)
13. Vacuum in different directions across your surfaces for best results
• After each cleaning session the water tank must be emptied and thoroughly rinsed and
dried before storing the unit. This will ensure that the unit continues to perform optimally
• The sponge filter (7) must be washed, rinsed and then air dried completely before
replacing it back into the machine
• The microparticle filter (4) should be inspected and cleaned when necessary
9.8.
8. Insert the vacuum hose (16) into vacuum
function hose port (10). The hose should
click into place
9. Join the 2-piece extension wand (18)
together and attach it the to the handle
end of the vacuum hose. Use a push and
twist action to secure
10.
10. Attach the appropriate cleaning head (19), (20), (23), (24), (25) or (26) to the free end of
the extension wand. Use a push and twist action to secure
NOTE: NEVER OPERATE YOUR HYDRO 15 WITHOUT ALL FILTERS PROPERLY INSTALLED
To Next Page
Loading...
