9.
CLEANING YOUR HYDRO 15:
1. Unplug the unit from the electricity supply
2. Take the unit to a drain or disposal area
3. Lift the locking clips (13) to unlock the motor unit
4. Lift the motor unit (3) from the water filter tank and place it to one side
5. Remove the filter housing assembly (5+6+7+8) by lifting it upwards
6. Remove the diffuser filter pipe (9-A)
10.9.
10. Remove the sponge filter guard (8), then
remove the sponge filter (7) and wash it
in warm water. Allow to air dry
completely before replacing in machine
8.7.
7. Empty the dirty water into the drain or
disposal area. Rinse the water tank and
the filter housing under running water
and dry them completely
8. Seperate the filter housing assembly by
turning the microparticle filter guard (6)
anticlockwise
11. Replacement microparticle filters are
available from the retail outlet where you
purchased your HYDRO 15
12. Reassemble only when completely dry and
store in a cool, dry place
WARNING:
NEVER OPERATE YOUR VACUUM
WITH WET FILTERS. ALLOW ALL
FILTERS TO AIR-DRY COMPLETELY
BEFORE REINSTALLING.
9. Remove the microparticle filter (4) from
the mechanical water-level detector (5)
by turning it anticlockwise. If the filter is
dirty, wash it in warm water
To Next Page
Loading...
