Bennett Read ONE 114 R

19
YOU ARE NOW READY TO START DEEP CLEANING!
The BENNETT READ ONE allows you, the user, to control the level of cleaning and drying
necessary for your carpet surface. The spray trigger should only be pressed when you need cleaning
solution to be sprayed onto the area being cleaned.
The brushes on the deep cleaning attachment play an important role in cleaning. Spraying cleaning solution is not enough to ensure
thorough deep cleaning is achieved; you will also need to use the brushes to loosen stubborn stains and dirt from your carpet.
The more cleaning solution you spray onto the carpet, the more time you will spend drying the carpet.
For stubborn stains or high traffic areas, lift tool completely from carpet. Aim spray at stubborn stain and spray liberally. Switch
off power switch. Making sure that the brushes are in contact with the surface, scrub vigorously over same area. Once satisfied with
the result, switch power on and suck up the stubborn stain until no more solution is visible in the attachment.
REMEMBER:
NOTE:
Holding the swivel handle, reach as far as you can
and place attachment on carpet, making sure that
attachment remains level with surface
Press spray trigger to release
cleaning solution
Slowly pull the wand towards you as you
continue spraying
1 2 3
4
6
5
7
Release spray trigger when you lift the tool from the carpet
For further drying, repeat the process without using the spray function until no more liquid is passing through the attachment
Repeat over the same area 3 times or until there is no more dirt visibly entering the cleaning attachment from the carpet
Once satisfied, move onto next area and repeat cleaning process