5
ASSEMBLY
1. Your WHISPER comes fully
assembled but we recommend you
check the following before vacuuming:
• Pre-motor filter [12] properly
installed:
Open the dirt container lid (9) by lifting
the release catch (10) as shown on pg
8. Slide the pre-motor filter into the slot
from the top and clip it into place:
• Post-motor HEPA filter [13]:
Slide the HEPA filter in and press
down gently to clip it into place:
• Dust Bag [11] properly
installed:
Insert the front plastic housing of the
Dust Bag into the machine (arrows
pointing down) by inserting the bottom
of the housing into the slot inside the
tank cavity until it clips into place:
SETTING UP YOUR
WHISPER:
1. Connect the flex-hose (5) to the
vacuum by inserting the hose
connector (6) on the end of the
flex-hose into the suction inlet (18). To
remove the flex-hose, press the two
tabs on either side of the connector
and pull the flex-hose outwards.
3. To extend the extension wand,
hold the grip and push it away from
you. To retract, hold the grip and pull
it towards you:
2. Connect hose handle (4) to the end
of the extension wand (2) and twist
slightly to tighten:
To Next Page
Loading...
Need help?
General
