To Next Page

To Previous Page

31 How to adjust your monitor

MIC LED indicator

Charging the connected device via USB-C™ port

The USB-C™ port on your monitor supports power delivery in standby mode yet it is disabled

by default. If video source via USB-C™ port is detected, you will be prompted to enable

USB-C™ power delivery function in monitor standby mode. Select Yes to proceed.

If USB-C Charging 60W from System has been turned to ON, the power delivery will

start without further notification.

Connecting multiple monitors via MST (Multi-Stream

Tra ns p or t)

With connection via the DP-IN and DP-OUT ports, you can output content to one or up to 4

monitors via MST function.

1. Connect your laptop to the USB-C™ / DP port on the monitor using a USB-C™ / DP

cable. Select YES to enable USB-C™ power delivery in monitor standby mode if you are

prompted to. The USB-C™ port supplies power to the laptop then even when the monitor

is in standby mode.

2. Go to System > MST > ON. Note the OSD menu can be launched and configured only

when input signal is detected.

3. Connect the second monitor to the first one using a DP cable as illustrated.

4. Follow Step 3 to connect the third and the fourth monitors if desired.

5. Power on the laptop and the monitors. On all the connected monitors, check the

configurations as described in Step 2.

Light color Description

Green The microphone is turned on and ready for use.

Amber The microphone is muted.

Off The microphone is not available.

LAN

DP cable

USB-C™ cable

BenQ BL2785TC User Manual

Questions and Answers: