BenQ DC C610 - Choosing the Screen Language; Setting the Date and Time; Using the Normal Mode; Using the Macro Mode

English
Using the Camera 7
3.1.3 Choosing the screen language
Follow the steps below to set the OSD (On-Screen Display) language.
1. Press the MENU button.
2. Press the [ ] button to select [Setup] menu.
3. Press the [ ] / [ ] button to select [Language], and
then press the OK button.
4. Select a language that you prefer by using the [ ] /
[ ] button.
5. Press the OK button after all fields are set.
• The language setting will be retained even if the camera is turned off.
3.1.4 Setting the date and time
The [Date/Time] screen will be displayed when:
• The camera is turned on for the first time.
• The camera is turned on after removing the battery
for a long period of time.
1. Select the item field by using the [ ] / [ ] button.
• To increase the value, press the [ ] button.
• To decrease the value, press the [ ] button.
2. Press the OK button after all fields are set.
3.1.5 Using the normal mode
The Normal mode [ ] is used to capture images where the
distance to the subject is 1.0 m to infinity. Select this mode for
general shooting, including portraits and scenery.
1. Set the focus switch to the [ ] position.
2. Compose your image.
3. Press the shutter button.
3.1.6 Using the macro mode
The Macro mode [ ] is used to capture a close-up of the
subject, such as flowers or insects. The effective range is between
0.6 m to 1.0 m.
1. Set the focus switch to the [ ] position.
2. Compose your image.
3. Press the shutter button.
DC_C610_UM.book FRI, September 22, 2006