BenQ LU935ST - Advanced Menu: Network Configuration Options; Advanced Menu: General Settings Overview

32 Menu operation
Network
Wired LAN
Status
DHCP On/Off
IP Address
Subnet Mask
Default Gateway
DNS Server
Apply
AMX Device Discovery On/Off
MAC Address (Wired)
Settings
Projector Installation
Front Table/Rear Table/Rear
Ceiling/Front Ceiling
Remote Receiver Front/Top/Front+Top
Auto Source Search On/Off
Auto Sync On/Off
Dynamic Dimming On/Off
HDR Auto/SRD/HDR10/HLG
Light Settings
Light Mode
Normal/ECO/Dimming/
Custom
Custom Brightness
Light Usage Time
Operation
Settings
Blank Timer
Disable/5 min/10 min/15 min/
20 min/25 min/30 min
Reminder
Message
On/Off
High Altitude
Mode
On/Off
Power On/Off
Settings
Direct Power On
Signal Power On
Auto Power Off
Power Off Timer
12V Trigger On/Off
Serial Port
Setting
Port Selection RS232/HDBaseT
Baud Rate
9600/14400/19200/38400/57600/
115200
HDMI Equalizer
HDMI 1
Auto/Lower/Low/Middle/High/
Higher
HDMI 2
Auto/Lower/Low/Middle/High/
Higher
Image Memory
Save Image
Memory
Memory-1/Memory-2/Memory-3/
Memory-4/Memory-5
Apply Image
Memory
Rename
Reset Settings Reset/Cancel
Main menu Submenu Options