BenQ MW769 User Manual (English)

Other manuals for BenQ MW769

User Manual101 pages

Specifications2 pages

Questions and Answers:

M
Michelle BushAug 10, 2025
How to fix a BenQ MW769 that does not turn on?
- J
  Jessica ColeAug 11, 2025
  If your BenQ Projector isn't turning on, there could be a few reasons. First, ensure the power cord is securely plugged into both the projector's AC inlet and a working power outlet, and that the power outlet switch is on. Second, if you've recently tried turning it on and it didn't work, the projector might be cooling down. Wait until the cooling process is complete before attempting to turn it on again.
V
Virginia SnyderAug 18, 2025
What to do if my BenQ MW769 Projector has no picture?
- S
  Sharon ChurchAug 18, 2025
  If your BenQ Projector is displaying no picture, several things could be the cause. First, make sure your video source is turned on and the signal cable is correctly connected. Second, verify that the projector is correctly connected to the input signal device. Third, ensure that you have selected the correct input signal using the SOURCE key on the projector or remote control. Finally, check that the lens cover is open.
J
James ShieldsAug 25, 2025
Why doesn't my BenQ MW769 Projector remote control work?
- R
  Ricky PatelAug 26, 2025
  If your BenQ Projector's remote control isn't working, consider these potential causes. The battery may be out of power, so replace it with a new one. There might be an obstacle between the remote control and the projector; if so, remove it. Finally, ensure you are within 8 meters (26 feet) of the projector.
R
Robin RodriguezSep 1, 2025
How to fix a blurred image on my BenQ Projector?
- P
  Patricia BlackwellSep 1, 2025
  If you're experiencing a blurred image with your BenQ Projector, there are a few things you can check. First, the projection lens may not be correctly focused, so adjust the focus using the focus ring. Second, the projector and the screen might not be aligned properly; adjust the projection angle, direction, and height of the unit if necessary. Finally, make sure the lens cover is open.