Maintenance
70
3. Remove the lamp cover by (a)
pushing the lamp cover upward and
(b) lifting it off.
• Do not turn the power on with
the lamp cover removed.
• Do not insert your fingers
between the lamp and the
projector. The sharp edges inside
the projector may cause injuries.
4. Loosen the screws that secure the
lamp.
5. Lift the handle so that it stands up.
Use the handle to slowly pull the
lamp out of the projector.
• Pulling it too quickly may cause
the lamp to break and scatter
broken glass in the projector.
• Do not place the lamp in locations
where water might splash on it,
children can reach it, or near
flammable materials.
• Do not insert your hands into the
projector after the lamp is
removed. If you touch the optical
components inside, it could cause
color unevenness and distortion
of the projected images.
6. Insert the new lamp into the lamp
comparent and make sure it fits in
the projector.
(a)
(b)
To Next Page
Loading...
