Need help?Do you have a question about the BenQ MX810ST and is the answer not in the manual?
General| Brightness | 3000 ANSI Lumens |
|---|---|
| Resolution | XGA (1024x768) |
| Contrast Ratio | 13000:1 |
| Weight | 3.6 kg |
| Display Technology | DLP |
| Zoom Ratio | 1.1x |
| Speakers | 10 W |
| Projection Size | 60" to 100" |
| Input Connectors | HDMI, VGA, Composite Video, S-Video |
| Power Consumption | 310W |
| Lamp Life | 4000 hours (standard), 10000 hours (eco mode) |
Do not look directly at the projector lens during operation.
Use stabilizer or UPS for unstable mains voltage.
Do not block projection lens to avoid overheating or fire.
Allow 45 mins cooling before lamp replacement.
Never replace parts unless projector is unplugged.
Do not place on unstable surfaces to prevent damage.
Dangerous high voltages inside; only lamp is user-serviceable.
Avoid poorly ventilated, high temp, humid, dusty, or high altitude locations.
Do not block vents, place on soft surfaces, or near flammables.
Operate on level surface; avoid tilting beyond specified angles.
Do not stand projector vertically to prevent tipping.
Do not step on or place objects on projector to prevent damage/injury.
Liquids can cause failure; disconnect and service if wet.
Use only BenQ kit; ensure secure installation for safety.
Details the buttons and their functions on the remote control.
Step-by-step guide to powering on and initial setup.
Covers adjusting projection angle, auto-adjustment, and fine-tuning clarity.
Explains how to correct image keystoning manually or automatically.
Guides on navigating and using the OSD menu system.
Covers physical security and password protection basics.
Details procedures for forgetting, recalling, and changing the password.
Step-by-step guide to turn off password security.
Procedures for proper shutdown and direct power off.
Details lamp hour tracking and methods to extend lamp life.
Alerts and messages regarding lamp replacement timing.
Step-by-step guide for replacing the projector lamp.
Addresses issues like no power, no picture, blurred image, remote control, and password errors.
To Next Page
