To Next PageTo Next PageHow to fix BenQ Projector that does not turn on?
If your BenQ Projector isn't turning on, here are a couple of things to check: * Ensure the power cord is securely plugged into both the projector's AC power jack and a working power outlet. If the outlet has a switch, make sure it's on. * If you've recently tried turning it on, wait for the cooling process to complete before attempting to power it on again.
What to do if BenQ Projector remote control does not work?
If your BenQ Projector remote control isn't working, try these steps: * Replace the battery with a new one. * Ensure there are no obstructions between the remote and the projector. * Make sure you are within 8 meters (26 feet) of the projector.
Why is my BenQ MX816ST Projector image blurred and how to fix it?
A blurred image on your BenQ projector can be caused by a few things. First, adjust the focus of the lens using the focus ring. Second, make sure that the projector and the screen are aligned properly, adjusting the projection angle, direction, and height if needed. Finally, ensure the lens cover is open.
What to do if the BenQ Projector remote control does not work?
If your BenQ projector's remote control isn't working, try these solutions: * **Battery:** Replace the battery with a new one. * **Obstacles:** Remove any obstacles between the remote control and the projector. * **Distance:** Ensure you are within 8 meters (26 feet) of the projector.
Why is my BenQ MX816ST image blurred?
If your BenQ Projector image is blurred, consider the following: * Adjust the focus of the lens using the focus ring. * Ensure the projector and screen are properly aligned by adjusting the projection angle, direction, and projector height if needed. * Verify that the lens cover is open.
What to do if my BenQ Projector has no picture?
If your BenQ Projector displays no picture, several factors could be responsible: * Ensure the video source is powered on and correctly connected. * Verify the projector is properly connected to the input signal device. * Select the correct input signal using the SOURCE key on the projector or remote. * Make sure the lens cover is open.
General| Brightness | 3000 ANSI Lumens |
|---|---|
| Resolution | XGA (1024x768) |
| Contrast Ratio | 13000:1 |
| Lamp Life (Economic) | 6000 hours |
| Weight | 2.6 kg |
| Display Technology | DLP |
| Zoom Ratio | 1.2x |
| Input Lag | 16 ms |
| Power Consumption (Standby) | <0.5W |
| Throw Ratio | 0.9 - 1.08 |
| Speakers | 10W |
| Input Terminals | HDMI, VGA, Composite, USB |
| Keystone Correction | Vertical ±40° |
| Aspect Ratio | 4:3 (native), 16:9 (compatible) |
