BenQ SH753P - Page 48

5. System
Setup:
Advanced
High Altitude
Mode
On/Off
Yes/No
Audio Settings
Mute
On/Off
Volume
Microphone
Volume
Power On/Off Ring
Tone
On/Off
Lamp Settings
Lamp Mode
Normal/Economic/SmartEco
Reset Lamp Timer
Reset/Cancel
Lamp Timer
Lamp Usage Time/
Equivalent Lamp Hour
Security Setting
Change Password
Change Security
Settings
Power On Lock
On/Off
Baud Rate
2400/4800/9600/14400/19200/
38400/57600/1152000
HDMI Equalizer
HDMI-1: Auto/lower/low/middle/
high/higher
HDMI-2/MHL or HDMI-2: Auto/
lower/low/middle/high/higher
Test Pattern
On/Off
Closed Caption
Closed Caption
Enable
On/Off
Caption Version
CC1/CC2/CC3/CC4
12V Trigger
On/Off
Standby Settings
Network
Enable network standby mode/ Switch
to normal standby mode
Microphone
On/Off
Monitor Out
On/Off
Audio Pass
Through
Off/Audio In/Audio L/R/HDMI/
HDMI/MHL
Network settings
Wired LAN
Status/DHCP/IP Address/Subnet
Mask/Default Gateway/DNS
Server/Apply
AMX Device
Discovery
On/Off
MAC Address
Reset All Settings
Reset / Cancel
6. Information
Current System
Status
Source
Picture Mode
Lamp Mode
Resolution
3D Format
Color System
Lamp Usage Time
Firmware Version
Note that the menu items are available when the projector detects at least one valid signal. If there
is no equipment connected to the projector or no signal detected, limited menu items are
accessible.
Operation
48