Maintenance 67
Resetting the lamp timer
11. After the startup logo displays, resetting the lamp timer via the OSD menu.
• Under the Advanced OSD menu, go to System Setup : Advanced > Reset
Lamp Timer, and select Reset.
• Under the Basic OSD menu, if there’s no signal connected to the projector, go
to Reset Lamp Timer and select Reset; if there are signals connected, go to
Settings > Reset Lamp Timer, and select Reset.
Do not reset if the lamp is not new or replaced as this could cause damage.
A "Reset Successfully" message displays to notify that the lamp time has been
reset to "0".
To Next Page
Loading...
