Bentlon 65880 - Maintenance; Maintenance and Safety Measures; Safety Measures

User Manual www.dancohr.com page 11
3. MAINTENANCE AND SAFETY MEASURES
3.1 Maintenance
• Remove stains immediately as otherwise they may become permanent or damage the vinyl. Be
careful in particular with suntan oil, insect repellents and make-up. Test stain removal first in an
inconspicuous place.
• Wipe the upholstery and housings down regularly with a damp soft cloth.
• Remove stains with a solution of soft household soap and use a soft cloth (if necessary a soft brush).
Remove the remains of the soap with a clean damp cloth and then dry the chair with a towel. Use
luke-warm water and do not saturate the upholstery. Make sure that you dry the seams properly.
• Stubborn stains can generally be removed with isopropylalcohol from the chemist’s; make sure that
you wipe it off with a damp cloth.
• If the stains cannot be removed from the upholstery, contact your supplier. NEVER use abrasives,
pan sponges, bleach or solvents such as methylated spirits, benzene, acetone, etc. These may make
the upholstery or plastic housings dull or damage them.
• Be careful with water nearby the electric foot control and the electric mains and make sure no water
can run into the column.
• Although the chair does not need maintenance, a regular check-up every two years is advisable.
Contact your dealer for this.
• When operating the chair is accompanied with a squeezing sound, this can be put right by dropping a
bit of thin oil, (sewing machine oil) on that spot. If this problem cannot be solved with this, please
contact your dealer.
3.2 Safety measures
These chairs are very well-made and have been manufactured to last many years. For optimum use it is
important that the chairs are used according to these instructions.
• Never sit on the back or leg support. If you do this, it may result in serious damage to the supporting
frame of the chair.
• The bottom of the client should always be on the seat of the chair, even when getting into a chair in
the massage position. This guarantees the stability of the whole unit.
• Do not stand on the foot operation cable and regularly check the leads for breakage. Replace these if
necessary.
• Make sure, that the power cord of the chair is in a correct condition. Check it regularly und have it
replaced in case of damage.