Need help?Do you have a question about the Bentone BG100 and is the answer not in the manual?
Essential warnings and safety instructions for installation and operation of the burner.
Details on capacity kW, gas volume at min/max output, and inlet pressures.
Electrical wiring diagram for 2-stage LGB22/LMG22/LME22 burners.
Electrical wiring diagram for modulating LMG22/LME22 burners.
Electrical wiring diagram for modulating LMG22 burners with R316 control.
Diagnosing faults and lockout conditions for the LGB burner control.
Understanding lock-out indicators and control programme status for LGB.
Details on the control programme sequence in case of faults for LGB.
Diagnosing faults and lockout conditions for the LMG burner control.
Reference table for blink codes indicating fault causes in LMG control.
Information on disruption display and colour codes for LME burner control.
Procedures for alarm triggers and limitations on start attempts for LME.
Electrical wiring diagram for LFL1 2-stage burners.
Electrical wiring diagram for LFL1 modulating burners.
Electrical wiring diagram for LFL1 modulating burners with R316.
Diagnosing faults and lockout conditions for the LFL1 burner control.
Detailed steps for performing leakage control on the gas supply system.
Example calculation for determining gas volume, including net calorific values.
Instructions for adjusting the outlet pressure or setpoint of the regulator.
Guidelines for adjusting the burner to the specific boiler and checking combustion.
Steps to follow after installation for initial burner start-up.
Information regarding service requirements and qualified personnel.
Principle of flame monitoring via ionisation current and measurement.
Procedure for adjusting the air pressure switch for safety and performance.
Checks to perform for troubleshooting and ensuring trouble-free operation.
General checks and common faults for gas burners to ensure proper operation.
Troubleshooting steps for issues like no flame or lockout after safety time.
To Next Page
General
