Need help?Do you have a question about the Bentone BG200 and is the answer not in the manual?
Read manual before assembly/commissioning. Observe manual contents for all personnel.
Electrical installation according to regulations, avoid risks of gas leaks, fire, or injury.
Diagram and components for 2-stage burner operation.
Diagram and components for modulating burner operation.
Gas volume and pressure specifications for different burner models and gas types.
Graphical representation of operating ranges (pressure vs. capacity) for burner models.
Schematic diagram of gas and air components for 2-stage or modulating burners.
Electrical schematic for 2-stage operation with LGB/LMG/LME controls.
List of components for LGB/LMG/LME 2-stage control systems.
Electrical schematic for modulating operation with LMG/LME controls.
Electrical schematic for R316 modulating operation with LMG controls.
Fault diagnosis, lockout indications, and control programs for LGB, LMG, LME controls.
Electrical schematic for 2-stage operation with LFL1 controls.
Electrical schematic for modulating operation with LFL1 controls.
Electrical schematic for R316 modulating operation with LFL1 controls.
Fault conditions and lockout indication for LFL1 control programme.
Procedure for leakage control of the gas supply system with solenoid valve closed.
Monitoring burner operation via ionisation principle and measuring current.
Adjusting the air pressure switch to stop the burner if air volume is reduced.
Adjusting the min. gas pressure switch to prevent burner start on low pressure.
Adjusting the max. gas pressure switch to stop the burner if gas pressure exceeds value.
Troubleshooting checks for electricity, gas, and air supply before calling service.
General checks for troubleshooting gas burner operation issues.
Table listing common faults (e.g., no start, no ignition) and their remedies.
Detailed remedies for various burner operational issues like pulsations or bad combustion.
To Next Page
General
