> Recording on video tape
16
Switch on the program you wish to
record
Switch on the video tape recorder
Press to make the video tape
recorder ready for recording
To record another program than the
one shown on the screen, key in its
program number
When you see the program you
wich to record on the screen,...
...press again to start recording
You may now press the TV (or SAT)
button and watch any program you
like
To return to your recording, press
V.TAPE
Press to pause the recording
Press again to stop recording, or...
...alternatively, press to resume
recording
The buttons high-lighted on the
drawing of the Beo4 remote control on
the next page are the buttons you must
use for recording one program while
watching another at the same time.
To do so, you must first switch on your
TV (or satellite module) – then the
video tape recorder. Then press the
RECORD button to switch the video
tape recorder to recording pause.
While the BeoCord VX 7000 is in
recording pause, you can find the
program you wish to record by keying
in its program number or by pressing
the step buttons
▲ or ▼.
When the program you wish to record
appears on the screen, press RECORD
again and recording starts immediately.
The STOP button pauses the recording.
You must press STOP twice to stop
recording entirely; or you can press
RECORD again to resume recording.
When you record TV programs in this
way, the video tape recorder does all the
work on its own*. This means that you
can switch back to TV (or switch to
satellite or any other source) and watch
any program you like while your
recording is progressing – or you may
even switch off the TV.
Just remember that – in order to return
to your recording – you must press the
V.TAPE button first.
Unless otherwise instructed, the video
tape recorder does not stop recording
until the tape runs out. If this happens,
the tape will be rewound to the
beginning and will then be ejected.
Recording one program – watching another
TV
To record one TV program while watching
another at the same time:
V TAPE
RECORD
RECORD
STOP
RECORD
then
0
9
through
To Next Page