3
-
3
.
5
59
phenomenon
Cant not turn it on
LCD garbled code
Show normal and
no output
There is an error in
the temperature
Treatment method
Whether the rear shell installation is
deformed, it can be loosened and reinstalled.
Display through the first calibration panel
of the advanced option.
Installation method
Check step
Common failure
1.Install expansion screw sleeve with pitch 59mm
on the wall.
2.Separate the upper cover and the lower cover
with a screwdriver,according to the direction of
the alignment. The wire passes through the back
cover to the slot and leaves about 20cm long
according to the actual situation
3.Fix the bottom shell to the wal,and finally fix
the wire.Cover the front shell on the bottom
shell.
The intelligent touch screen thermostat is installed where it is
easy for the user to watch the screen and adjust the
temperature setting point.And make the thermostat located in
a place that can represent the overall ambent temperature of
the room.Avoid installing thermostats near cold and heat
sources,such as vents,heaters,outdoors or places where the
sun shine.
1.Check whether the battery is installed upside down
2.Check whether the boot button is valid
1.Check whether the connection between the main control board
and the power board is damaged
2.Check if the output has the wrong connection.
To Previous Page
Loading...
