NOTICE
Material damage from incorrect disinfectants or incorrect use of
disinfectants!
Using the incorrect disinfectants or using the disinfectant incor‐
rectly can cause damage to the product, therefore you must com‐
ply with the following disinfection instructions.
1. It is important to only use surface disinfectants in the
concen-trations specified by the manufacturer.
2. If surface disinfectants not applied correctly causing a
large amount of fluid to remain on the surface, surface
deposits may develop since the product is applied and
not removed. If increased surface deposits due to sur-
face disinfectants occur, the system must be thoroughly
cleaned.
3. Only use disinfectants that are chloride or halogen free
to avoid damaging the stainless steel parts.
4. Avoid contact with aldehyde- and amine-base prod-
ucts! Perform a preliminary cleaning before first use of al-
dehyde disinfectants (especially if an amine-containing
product was previously used). Non-compliance can re-
sult in residues that are impossible to remove.
5. Immediately rinse and dry all surfaces that come into
contact with quaternary cleaning agents! Table com-
ponents can otherwise corrode over time.
6. Contact the manufacturer of the disinfectant with any
questions or concerns about microbiological efficacy.
NOTICE
Material damage from harsh cleaning products!
Harsh cleaning products can damage finished surfaces.
1. Do not use harsh cleaning products!
1. Clean finished surfaces weekly with mild, soapy water and a clean,
damp and frequently rinsed cloth.
Cleaning finished surfaces
Operator Manual Surgical Mobile Operating Table Models D860, D850, D 830, D820, D770, D760
Operation
55
To Next Page
Loading...
