Need help?Do you have a question about the Beretta EXCLUSIVE C Series and is the answer not in the manual?
General warnings and safety precautions for installation and operation.
Regulations, safety, electrical, gas, and flue connections for installation.
Positioning, connections, pipework, and flue installation procedures.
Essential checks before the first ignition of the boiler by a qualified engineer.
Guided procedure for initial system configuration after firmware update.
Configuring weather compensation for heating based on outdoor temperature.
Procedure for initial startup, including setting boiler mode and checking vent cycle.
Troubleshooting guide for boiler ignition failures and fault codes.
Procedure for performing combustion analysis and checking readings.
Explanation of error codes, fault messages, and LED indicators.
Restoring the boiler to its original factory settings by an engineer.
Procedure for reconfiguring the system after a boiler reset.
Checking and potentially re-programming combustion parameters.
Essential annual maintenance tasks and warranty requirements.
Details on warranty conditions requiring annual servicing and proper maintenance.
To Next Page
General