Need help?Do you have a question about the Beretta EXCLUSIVE C and is the answer not in the manual?
Installation must be carried out by qualified personnel, in compliance with standards.
Procedure for removing air from the heating circuit and boiler, often during initial installation.
Details on mounting the boiler support plate and making hydraulic connections.
Instructions for low and high voltage connections, including safety requirements.
Procedure for connecting the gas supply, ensuring correct gas type.
Guidelines for flue gas evacuation and combustion air intake according to standards.
Settings for temperature regulation, including climatic curves and ambient influence.
Essential checks before the first ignition of the boiler by qualified personnel.
Steps to program the boiler's settings, including time and date.
Configuring boiler parameters like type of system and operating modes.
Customizing heating zone management via ZONES MANAGER menu.
Configuring thermoregulation based on outdoor sensor and building insulation.
Selecting compensation curves for thermoregulation based on system type.
Steps for initial boiler startup, including gas flow and room thermostat adjustment.
Procedure for configuring the system after reset or REC10 replacement.
Steps to take before performing maintenance, including safety checks.
Changing the heating setpoint and confirming the selection.
Changing the domestic hot water setpoint and confirming the selection.
To Next Page
General