Need help?Do you have a question about the Beretta EXCLUSIVE R and is the answer not in the manual?
Installer and user manual for the Exclusive R boiler model.
Explanation of symbols used and information on range rated boilers.
Essential safety warnings for installation, operation, and maintenance.
Overview of the boiler's ACC system and operating modes.
Procedures for cleaning the heating system and water quality parameters.
Details on positioning the boiler and making hydraulic connections.
Description of the user interface, operating status, and alarm indications.
Explanation of the REC10 control panel's display, keys, and status icons.
Essential checks to perform before the first ignition of the boiler.
Step-by-step guide to programming the boiler settings.
Customizing boiler operation through parameter settings.
Customizing heating zone management and parameters.
Configuration of the automatic anti-legionella function for storage tanks.
Setting time schedules for heating and domestic hot water.
Configuration of thermoregulation using outdoor temperature sensors.
Choosing the correct compensation curve for heating systems.
Detailed steps for the initial start-up and commissioning process.
Adjusting heating water temperature with/without outdoor sensor.
Setting the domestic hot water temperature for storage tanks.
Steps for starting up the boiler and its operation.
Procedure for resetting the boiler after a fault.
Instructions for converting the boiler between gas types.
Procedure for performing a combustion analysis.
Adapting the boiler to system requirements by setting max flow rate.
Information on boiler status lights and fault code display.
Troubleshooting specific faults like water transducer and heat exchanger.
Accessing and viewing the boiler's alarm history.
Configuring the storage tank type and settings.
Procedure for safely switching off the boiler for extended periods.
Restoring the boiler to factory default settings.
Guided procedure for configuring the system after reset or replacement.
Instructions for replacing REC10 MASTER and AKM01 boards.
Adjusting combustion parameters after control unit replacement.
Essential periodic maintenance tasks for safety and efficiency.
Maintenance for combustion control system, electrodes, and gas valve.
Detailed explanation of the REC10 control panel's interface and keys.
Meaning of icons displayed on the REC10 to indicate system status.
Navigating the initial start screen and available functions.
Setting the operating modes for the boiler and main zone.
Adjusting heating and domestic hot water setpoints via REC10.
Accessing system settings including time, date, and language.
Detailed configuration of time schedules for heating and DHW.
Functions for adding, modifying, or deleting time frames in schedules.
Copying scheduled time frames between days.
Displaying fault codes and descriptions on the REC10 panel.
Procedure for resetting the boiler after a fault condition occurs.
To Next Page
General