Berner BHPC 150-2 - Page 6

6 Original instructions
Transporting the high pressure washer
• :KHQWUDQVSRUWLQJWKHPDFKLQHLQRURQDYHKLFOHLW
PXVWEHVHFXUHGHJZLWKVWUDSVVRWKDWLWFDQQRW
slip or tip over.
• BERNER recommends that the machine is positioned
KRUL]RQWDOO\RQWKHEDFNVLGHZKHQWUDQVSRUWHGLQRU
on a vehicle.
Detergents
• This machine has been designed for use with clean-
ing agents supplied or recommended by BERNER.
The use of other cleaning agents or chemicals may
DGYHUVHO\DႇHFWWKHIXQFWLRQRIWKHPDFKLQH
 Before starting the work
Inspecting the machine
• Do not use the machine if a supply cord or important
SDUWVRIWKHPDFKLQHDUHGDPDJHGHJVDIHW\GH-
YLFHKLJKSUHVVXUHKRVHDQGVSUD\KDQGOHDQGVSUD\
attachments.
• The trigger of the spray handle must move easily and
automatically return to its starting position when re-
leased.
• Always keep high pressure hose and spray attach-
PHQWLQJRRGFRQGLWLRQFOHDQPRYLQJHDVLO\DQGFRU-
rectly assembled.
Electrical connection
WARNING!
Minimize the risk for electrical shock:
• Voltage and frequency of the machine (see rating
plate) must match the voltage of and frequency of the
mains supply.
• Only connect the machine to electrical installation made
E\DFHUWL¿HGHOHFWULFLDQDQGFRPSO\ZLWK,(&
• It is recommended that the electrical supply to the ma-
chine should include a residual current device that will
interrupt the supply if the leakage current to earth ex-
ceeds 30 mA for 30 ms.
,
,