3
Clean and Lubricate
The best way to remove lint from the machine is with
compressed air. Blow all the lint from the machine. Remove all
lint from the gears and again from the bobbin area and feed
dogs.
When oiling your machine make sure you use a good quality
oiler and clear sewing machine oil.
This type of oiler is good because it has an extendable
spout and only lets out small drops of oil. A drop of oil is the
amount of oil left on the tip of a needle if you did it in oil.
Clean all lint from the open arm area and needle bar area. You
can access the needle bar area from the back though the access
holes. Oil all moving parts but be careful to use very little oil in
the needle bar area as the oil will find its way onto your fabric.
Clean off any excess with a soft cloth.
To Next Page
Loading...
