Bernina aurora 435 - Page 52

Servicemanual_aurora_435_450_english_V3_032530.50.04_Korrektur.doc 52
SP 10.6 BSR Information – boot loader version
SP 10.7 BSR Information – hardware version
SP 10.8 BSR information calibration rate
What to test: SP 10.6 Display of installed version
What to adjust:
Attach BSR foot
Press key 10 six times in the basic
program.
Press key 18 to confirm selected test.
Press OK key to exit and return to basic
program.
Desired status:
Each test type is displayed in the matrix
(symbol g) until
activated by pressing key 18 (start/stop).
The version is displayed in the matrix.
symbol g
Repair note:
• update
What to test: SP 10.7 Display of hardware version
What to adjust:
Attach BSR foot
Press key 10 seven times in the basic
program.
Press key 18 to confirm selected test.
Press OK key to exit and return to basic
program.
Desired status:
Each test type is displayed in the matrix
(symbol g) until activated by pressing key
18 (start/stop).
The hardware version is displayed in the
matrix. symbol g
Repair note:
• none
What to test: SP 10.8 Display calibriation rate
What to adjust:
Attach BSR foot
Press key 10 eight times in the basic
program. Press key 18 to confirm selected
test.
Desired status:
Each test type is displayed in the matrix
(symbol g) until activated by pressing key
18 (start/stop).
The X / Y dissolution is indicated in the
matrix symbol g
Repair note:
• BSR foot can only calibriated in the
factory.
• none