Bertazzoni REF36FDFZXNT - Connecting the Water Line

13
2.7
A
C
B
Connecting the water line
1 Shut off the main water supply line..
2 Install a shut off valve and water line. -
compression thread UNS 7 16 24 accessible with( / - ),
product in place Refer to local code and instructions.
with water line installation kit not included( ).
3 Connect the newly installed water supply line C(. )
to the refrigerator water inlet connector B tighten( ),
using tool.
4 Gently tug on the supply waterline to ensure a.
proper fit and risk of damage when pulling or pushing
the unit for cleaning.
5 Turn main water back on and check for leaks..
A
B
Connecting the water line
Water line installation kits are available as an
additional accessory from your delaer or at a
local hardware store.
Observe local regulations and the connection
conditions of the local water supply companies.
6. After connecting the water line, please flush one
gallon of water through the filter before drinking or
using the water from your refrigerator. (Flush
approximately 5 minutes). To flush, press a large
glass or cup against the water dispenser lever.
Fill the glass, then empty it. Repeat until you
dispense about one gallon of water.
0.20 Mpa(2.06 bar, 30PISG)
0.68 Mpa(6.89 bar, 100PISG)
Pressure over 0.68 Mpa(6.89 bar, 100PISG)
0.20 Mpa(2.06 bar, 30PISG) and
0.68 Mpa(6.89 bar, 100PISG)