BestPack AS22-2 - Troubleshooting Guide; Common Problems and Solutions

Automatic Uniform Sidedrive Carton Sealer (AS)
19
Troubleshooting
TROUBLESHOOTING
Review SETUP PROCEDURE to ensure setup is correct. If correct, the troubleshooting chart below
lists possible problems, causes, corrections, and reference guide.
PROBLEM POSSIBLE CAUSES CORRECTION
1. Drive belts do not
convey boxes
Narrow boxes
Check machine specications. Boxes
are narrower than recommended causing
slippage and premature belt wear.
Worn drive belts Replace drive belts
Top ap compression rollers
in too tight
Readjust compression rollers
Top tape head does not
apply enough pressure
Adjust the box height adjustment with the
crank
2. Drive belts do not
turn
Worn bearings, gears, or
driving shaft
Replace ball bearing, gears, or driving shaft
Drive belt tension too loose Adjust belt tension screw
Electrical disconnect Check power and electrical plug
Motor not running
Check the fuse, capacitor, and setting of
thermal relay
3. Drive belts break Worn belt Replace belt
4. Light boxes tip
back on exit
Top drive frame down too
far
Carefully adjust top drive frame
5. Squeaking noise
as boxes pass
through machine
Dry belt plastic pulleys Lubricate belt pulleys
Driving idler rollers
Lubricate aluminum pulleys and replace, if
defective
* Denotes to reference your tape head manual