IMPORTANT! - We ask if you can always provide the WOC (Works Order Card)
number and or the engine serial number in all communications concerning your engine
4
ENGINE IDENTIFICATION
A full inspection of the engine must be made immediately on delivery to confirm that there is no damage. If there is
any damage then write this clearly on the delivery note and inform your dealer or Beta Marine within 24 hours. A
photograph would always help.
INITIAL RECEIPT OF THE ENGINE
The engine serial number is difficult to see. It is stamped
on the crank case above starter motor and below the heat
exchanger, on the port side of the engine. The number is
also shown on the rocker cover label.
BETA 28, BETA 30, BETA 35 & BETA 38
The engine must be stored in a dry, frost free area and this is best done in its packing case. If storage is to be more
than six months then the engine must be inhibited (contact your dealer or Beta Marine). Failure to inhibit the engine
may result in the formation of rust in the injection system and the engine bores, this could invalidate the warranty.
ENGINE STORAGE
1 Beta Marine WOC Number
3 Engine Serial Number
2
1640_Aug_2013.qxd:beta 1660 manual 18/11/13 10:47 Page 4
To Next Page
Loading...
