3
CHECKS AND MAINTENANCE
45
GB
CHECKING THE OIL LEVEL IN THE HY-
DRAULIC CLUTCH
To check the oil level in the clutch pump,
fi rst remove cover 2.
Remove the two screws 1 and take off
cover 2 together with the rubber bellows.
With the clutch pump in a horizontal posi-
tion, the level of the oil should be 5 mm
below the upper rim.
If necessary top up with “BARDAHL BRA-
KE FLUID DOT 4” hydraulic oil, which is
available from your BETAMOTOR dealer.
BLEEDING THE HYDRAULIC CLUTCH
To bleed air from the rear clutch pump,
proceed as follows:
•Open the sump cap.
•Insert one end of a trasparent tube into
a container.
•Pump with the clutch lever 2/3 times and
keep the lever pressed.
•Unscrew the valve and let the oil drain.
•If are still visible in the tube repeat above
aperation until obtaining a continuous
outfl ow of oil within no air bubles.
•Close the valve and release the lever.
NOTE:
The pump is suitable for bleeding in depres-
sion. During this procedure, continuosly top
uo the clutch pump thank to replace the oil
that is out fl owing.
•Remove the tube.
3
2
1
To Next Page
Loading...
