Better BT-532C - Page 19

BT-532C User manual
19
Default
0
Supporting
model
All
Notes
When the user-defined character set is canceled, the built-in character set is
automatically selected.
Usage example
N/A
Define user-defined characters
Name
Define user-defined characters
Format
ASCII ：ESC & y c1 c2 [x1 d1 ... d (yx1)] ... [xk d1 ... d(y x k)]
Decimal ：27 38 y c1 c2 [x1 d1 ... d(yx1)] ...[xk d1 ... d(yxk)]
Hexadecimal ：1B 26 y c1 c2 [x1 d1...d(y x1)]...[xk d1...d(yxk)]
Description
Defines user-defined characters.
y specifies the number of bytes in the vertical direction.
c1 specifies the beginning character code for the definition, and c2 specifies
the final code.
x specifies the number of dots in the horizontal direction.
Parameter range
y=3
32≤c1≤c2≤126
0≤x≤12 (when Font A (12×24) is selected)
0≤d1 … d(y×xk) ≤255
Default
N/A
Supporting
model
All
Notes
 The allowable character code range is from ASCII code <20>H to <7E>H
(95 characters).
 It is possible to define multiple characters for consecutive character codes.
If only one character is desired, use c1=c2.
 d is the dot data for the characters. The dot pattern is in the horizontal
direction from the left side. Any remaining dots on the right side are
blank.
 The data to define user-defined characters is (y×x) bytes.