EasyManua.ls Logo

Beurer BM 53 - General Precautions

Beurer BM 53
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
28
Do not use the device outside of the specified storage
and operating conditions. This could lead to incorrect
measurements.
Only use the cuffs included in delivery or described in
these instructions for use with the device. Using a differ-
ent cuff may lead to inaccurate measurements.
Note that when inflating the cuff, the functions of the limb
affected may be impaired.
Do not perform measurements more frequently than nec-
essary. Due to the restriction of blood flow, some bruis-
ing may occur.
Blood circulation must not be stopped for an unneces-
sarily long time during the blood pressure measurement.
If the device malfunctions, remove the cuff from the arm.
Place the cuff on the upper arm only. Do not place the
cuff on other parts of the body.
The air line poses a risk of strangulation for small chil-
dren.
Small parts may present a choking hazard for small
children if swallowed. They should therefore always be
supervised
Do not drop, step on or shake the device.
Do not disassemble the device as this may cause dam-
age, faults and malfunctions.
If you have any of the following conditions, it is essential
you consult your doctor before using the device: Cardiac
arrhythmia, circulatory disorders, diabetes, hypotension,
chills, shivering
To rule out a difference between sides, the measurement
should initially be taken on both arms.
Never operate the device during maintenance work.
Maintenance work includes maintenance, inspection and
repair.
General precautions
CAUTION
The blood pressure monitor is made from precision and
electronic components. The accuracy of the measure-
ments and service life of the device depend on its careful
handling.
Protect the device and its mains adapter from impacts,
humidity, dirt, marked temperature fluctuations and di-
rect sunlight.
Ensure the device is at room temperature before taking a
measurement. If the measuring device has been stored
close to the maximum or minimum storage and trans-
port temperatures and is placed in an environment with
a temperature of 20°C, it is recommended that you wait
approx. 2 hours before using the measuring device.
Do not use the device in the vicinity of strong electro-
magnetic fields and keep it away from radio systems or
mobile telephones.
We recommend removing the batteries if the device is
not going to be used for a prolonged period of time.
Avoid any mechanical restriction, compression or bend-
ing of the cuff line.

Table of Contents

Related product manuals