20
Individual measured values
•
W
hen the relevant memory button
(M1 or M2) is pressed again, the last
individual measurement is displayed
(in this example, measurement 03).
•
W
hen the relevant memory button
(M1 or M2) is pressed again, you can
view your individual measurements.
•
T
o switch the device off again, press the START/
STOP button or wait 30 sec.
You can exit the menu at any time by pressing
the START/STOP button .
Deleting measured values
• To clear the memory of the relevant user memory,
you must first select a user memory.
• Start individual measurement access.
• Press and hold the M1 & M2 memory buttons for
5 seconds.
All the values in the current user memory
are deleted.
7. Evaluating results
NOTE:
A single measurement does not provide an accurate indica-
tion of your true blood pressure. You need to take and record
several readings over a period of time. Try to measure your
blood pressure at the same time each day for consistency.
7.1 Irregular heartbeat symbol
This symbol indicates that certain heartbeat/pulse ir-
regularities were detected during the measurement.
NOTE:
• Talking, moving, shaking or an irregular pulse during the
measurement can result in the appearance of this symbol.
•
Repeat the measurement if the flashing icon
is
displayed after the measurement. Please note that you
should rest at least 5 minutes between measurements
and not talk or move during the measurement. If the icon
continues to be displayed in subsequent readings, we
recommend you to consult your physician in order to de-
termine if it is cause for concern. Do not try to interpret
readings or attempt to treat any condition yourself. Al-
ways follow the guidance of a health professional. If you
have an emergency call 911 immediately.
To Next Page
Loading...
