Electrical safety
The unit is protected against overheating by an automatic thermal cut-off Protective insulation.
Proper use
The unit is intended for directing infrared radiation at the human body.
Any other use is regarded as improper. This unit is not designed for commercial use, but for use in the private home!
Description of device and accessories
1 Swivelling body with handles
2 Disc
3 On/Off switch
4 Remaining time display
5 Time selector
6 Foot with integrated cable channel for coiling the power cable.
Initial use
• Place the unit on a solid and even surface. The unit must not be set up on a slope or laying down.
• The minimum distance between flammable items and the infrared lamp must not be less than 40 inches (1 m).
Operation
Unpacking and setup
• The timer switches off automatically at the end of the set time.
• The swiveling body allows you to adjust the infrared heat lamp to suit your needs.
• Insert the plug into a wall outlet.
• Switch on the unit at the On/Off switch (3). The remaining time display (4) shows 15 minutes.
• Set the desired treatment time (1 to 15 minutes) by pressing the time selector (5) several times.
• The set time will appear on the display (4).
Preparing for treatment
• Arrange yourself in front of the unit so you can relax and enjoy the treatment of the part of the body concerned.
• Tilt the lamp so the unit is angled directly at the part of the body being treated.
• The distance to the infrared heat lamp depends largely on personal heat sensitivity and the treatment concerned.
• Make sure the distance between the infrared heat lamp and the part of the body being treated is not less than 12
inches (30 cm) and not more than 16 inches (40 cm)!
Do not use the unit for more than 15 minutes at a time (risk of overheating). Allow the unit to cool down before you
use it again.
Treatment duration
To Next Page
