Beurer IL 50 - Starting and During Treatment; Starting the Unit and Monitoring

Important
Risk of burns: Remove any metal items, e.g. belt buckles, necklaces, bras, jewellery or piercings, from the treatment
area before switching on the device as they can become very hot.
We recommend short treatment times at the beginning.
However, even when the unit is used correctly, the skin of some people can have an oversensitive or allergic
reaction to the heat treatment (e.g. intense redness, blisters, itching, heavy sweating).
Starting the unit
Important
• Always close or cover your eyes when radiating the face.
• Press the On/Off switch (3)
• The unit will turn on automatically after a short time.
• The Time Display (4) will show 15 minutes (Recommended treatment time).
• You can press the time selector (5) to reduce the treatment time. Each push reduces the time by 1 minute.
• The infrared heat lamp switches off automatically after the set time.
• To end the treatment before the timer runs out, use the On/Off switch (3) and disconnect the power plug.
Important: Do not touch the hot glass
During treatment
• Examine the part of the body treated frequently and check for skin reactions. Cease exposure immediately if there
are any signs of oversensitivity or an allergic reaction, and consult a doctor.
• The unit can be switched off at any time using the On/Off switch (3).
• Do not cover up or pack the unit away while it is still warm.
After treatment
• The fan will continue running for 5 minutes after you have finished using the device in order to cool it down. Please
do not unplug the device during this period.
• Once the cooling period has finished, the fan will switch itself off. Switch off the device and remove the mains plug
from the socket.
Note: The bulb is fragile when hot. After operation, let the device cool down before you move it.
Cleaning
Before cleaning the unit, switch it off, unplug it and allow it to cool down completely before you touch it or pack it
away.
The unit can be cleaned with a damp cloth. Do not use cleaning agents.
Ensure that no water enters the unit.
Changing the infrared lamp
NOTICE:
Remember that a faulty lamp should only be replaced with a lamp of the same type.
WARNING:
Danger of electric shock!
• Before changing the lamp, switch the device off, unplug it and allow it to cool down completely.
• Light bulbs are not covered by warranty.
• Risk of burning on hot surfaces!
NOTICE:
Always hold the bulb by the end, do not touch the bulb.
Procedure