Beyerdynamic AVENTHO 300 - Multi-Point Operation; Setting up Multi-Point; Using Multi-Point; Delete Pairing List

6
EN
AVENTHO 300 — Wireless Over-Ear Headphones
Multi-point operation
The AVENTHO 300 can be paired with up to eight devices
via Bluetooth®. An active connection is possible with a
maximum of two devices at the same time.
Music playback and phone operation is only possible
with one device at a time. Phone operation has priority
over music playback, i.e. music playback is interrupted
when a call is received.
The following priority li applies to the use of playback
devices (PD):
Priority Profile Playback devices (PD)
1 HFP (phone operation) PD 1 (device used fir)
2 HFP (phone operation) PD 2 (device used
second)
3 A2DP
(playback of music)
PD 1 (device used fir)
4 A2DP
(playback of music)
PD 2 (device used
second)
Setting up multi-point
� Connect the AVENTHO 300 to the fir device
(see “Pairing”).
� Deactivate the Bluetooth® connection on the fir
device.
� Switch o the AVENTHO 300.
� Press the on/o button 7 for 6 seconds to a
the connection mode (atus LED 6 flashes slowly
alternately blue and red).
� Connect the AVENTHO 300 to the second device
(see “Pairing”).
� Reactivate the Bluetooth® connection of the fir
device, which automatically connects to the
AVENTHO 300.
� When both devices are paired with the AVENTHO 300,
the AVENTHO 300 automatically connects to both
devices each time it is switched on.
Using multi-point
Media playback active /
accept call
Briefly tap the touch pad
twice (
)
Hang up / a media
playback again
Briefly tap the touch pad
twice (
)
Delete pairing li
� Press and hold the on/o
button of the switched o
AVENTHO 300 for approx.
8 seconds, until the atus
LED flashes yellow.
Switching the headphone on and o
� Switching on
Aer you have paired
the AVENTHO 300 or use
it with a cable, press and
hold the on/o button
for approx. 2 seconds
(
).
The atus LED lights up
once and then goes out.
It displays the respective
charge level.
� Switching o
Press and hold the on/o button
for approx. 6 seconds (
).
Switch between noise cancellation (ANC)
and transparency mode
You can use the ANC button to switch between noise
cancellation (ANC), transparency mode and OFF mode.
The AVENTHO 300 is supplied in OFF mode.
� If you press the ANC
button once each time,
the transparency mode,
the ANC mode and then
the OFF mode again is
activated one aer the
other.
� If you press the ANC
button twice each time,
the ANC mode, the
transparency mode and
then the OFF mode is
activated again.
If the transparency mode is only to be activated
temporarily when wearing the AVENTHO 300, place
the palm of your hand on the right side of the touch
pad.
If you are using the AVENTHO 300 with cable, you
mu also switch it on to be able to use all available
functions.
You can make settings for noise cancellation (ANC)
and transparency mode in the beyerdynamic app.