Bezzera BZ02 PM - Coffee Preparation

32
cod.9941038.01 ed.02/04 rev.01
BZ02PM_BZ02DE
English
5.3 Coffee Preparation
BZ02 PM
1) Remove the filter holder (fig. 1; pos. 2) from the supply group (fig. 1; pos. 5).
2) Put the ground coffeee into the filter holder, press it and make attention that the
filter holder edge is not dirty with coffee.
3) Replace the filter holder in its housing.
4) Press the coffee supply key (fig. 1; pos. 6).
5) Press again the above key (fig. 1; pos. 6) to stop the coffee supply.
Caution:
- Do not remove the filter holder filled with coffee when the equipment is operating
because it is under preassure.
- Do not touch expressly the metal plating of the filter holder; danger of burns.
BZ02 DE
1) Remove the filter holder (fig. 1; pos. 2) from the supply group (fig. 1; pos. 5).
2) Put the ground coffeee into the filter holder, press it and make attention that the
filter holder edge is not dirty with coffee.
3) Replace the filter holder in its housing.
4) Press one of the keys of the coffee distribution keypad (fig. 2) according to the
desired dose.
Follow the instructions of paragraph 5.7 of this booklet in order to change the dose
programming.
The machine is preset for the continuous distribution: press the key “PROG” (fig. 2;
pos. 1) to start the distribution, press it again to stop it.
Caution:
- Do not remove the filter holder filled with coffee when the equipment is operating
because it is under preassure.