Bezzera BZ02 PM - Page 38

38
cod.9941038.01 ed.02/04 rev.01
BZ02PM_BZ02DE
English
Possible causes:
1-The cups are cold.
2-
The filter holders are cold.
3-
The coffee grind is too fine.
4-The water circuit of the
machine is dirty
(milestone)
.
5-The boiler pressure is
lower than 0,8 BAR
.
In case 1 use the cup
heater.
In case 2, keep the filter
holder mounted on the
group.
In case 3 change the
coffee grind.
In cases 4-5 call a skilled
technician.
THE COFFEE IS TOO
COLD
The coffee is tepid,
although the pressure is
normal between 1 and
1,2 BAR. In this case, the
pressure measurement is
dummy.
Call a skilled technician
to check the relief valve.
Meanwhile, in order to
use the machine, open
the steam valve, the
boiler pressure will drop
to zero: in this way, the
heat elements will be
connected and the
temperature will increase.
Carry on this operation
every day when turning
on the machine.
THE COFFEE IS TEPID
Possible causes:
1-The boiler pressure is
higher than 1,3 bar
.
2-The machine is covered
with something that
prevents its cooling.
3-The machine has been
installed in a position that
prevents air circulation.
In case 1 call a skilled
technician.
In cases 2-3 reset the
machine cooling
conditions.
THE COFFEE IS TOO
HOT
The coffee dose set is not
respected, but the
dispensing goes on.
Call a skilled technician.*AFTER THE
SELECTION, THE
COFFEE DISPENSING
SWITCH BLINKS
*(only for DE machines)