BFI Automation 2.0L - General Aspects; Introduction, Warnings, and Responsibilities; Safety; Intended Use, Personnel, and Safety Procedures

Content
iii
1 General aspects 1-1
1.1 Introduction 1-1
1.2 Warning notes 1-2
1.3 Copyright protection 1-3
1.4 Disposal information 1-3
1.5 Warranty 1-4
1.6 Obligation of the operating company 1-5
1.7 Liability disclaimer 1-6
1.8 Declaration of conformity 1-7
1.9 Address of the manufacturer 1-8
2 Safety 2-1
2.1 Intended use 2-1
2.2 Requirements on persons 2-2
2.3 Safety instructions 2-3
2.4 Safety devices 2-4
2.4.1 Fundamental aspects 2-4
2.4.2 Safety devices on the flame scanner 2-4
2.5 Safety instructions in case of maintenance and troubleshooting 2-5
2.5.1 Fundamental aspects 2-5
2.5.2 Electrical / electronic devices 2-6
2.5.3 Testing in keeping with the German Workplace Safety Ordinance (BetrSichV) 2-7
2.5.4 Safety test 2-7
3 Technical data 3-1
3.1 General characteristic features 3-1
3.2 Electrical system, optical system, mechanical system 3-1
3.3 Weight 3-3
3.4 Dimensions 3-3
3.5 Adjustment controls 3-3
3.5.1 Sensitivity potentiometer 3-3
3.6 Device design - block diagram of the flame scanner 3-4
4 Transport, installation and connection 4-1
4.1 Scope of delivery 4-1
4.2 Packaging 4-2
4.3 Forwarding instructions 4-2
4.4 Weight - flame scanner 4-2
4.5 Space requirement 4-3
4.6 Installation 4-5
4.6.1 Company adjustment of the flame scanner 4-8
4.6.2 Adapting the flame scanner to the fuel 4-9
4.7 Connection 4-10
4.7.1 Electrical connection for standard housing (ATEX Zone 2) 4-10
4.7.2 Laying the special cable KW5 for standard housing (ATEX Zone 2) 4-11
4.7.3 Electrical connection for Ex-housings (ATEX Zone 1) 4-12
4.7.4 Laying the special cable KW5 for Ex-housing (ATEX Zone 1) 4-13
4.8 Storage 4-14