To Next PageTo Next Page
Need help?Do you have a question about the BFT ARES ULTRA BT A1000 and is the answer not in the manual?
General| Motor Voltage | 24 V |
|---|---|
| Max Gate Weight | 1000 kg |
| Limit Switch Type | Magnetic |
| Power Supply | 230 V |
| Power Consumption | 300 W |
| Remote Control | Yes |
| Bluetooth Connectivity | Yes |
| Safety Sensors | Yes |
| Manual Release | Yes |
| Operating Temperature | -20°C to 55°C |
Introduction to the rack sliding gate actuator, its models, and main functionalities.
Pre-installation steps for tube layout and motor fixture preparation.
Instructions for mounting the motor and installing drive accessories like rack.
Procedure for attaching limit switch brackets and setting them.
Overview of the simplified menu and parameter settings.
Details on logic options and preset configurations within the menu.
Visual guide to navigating the simplified menu.
Guide to accessing different control menus like Parameters, Logic, and Radio.
Explanation of diagnostic codes and error messages for troubleshooting.
Essential safety instructions and precautions for installers during setup.
Detailed technical data for the actuator, including power, speed, and weight limits.
Overview of the actuator's general information and initial testing procedures.
Guidelines for proper wiring and terminal board connections.
Detailed descriptions of terminal board connections for motor, auxiliary, and safety devices.
Configuration options for auxiliary outputs and their functions.
Configuration options for various command inputs like Start, Open, Close.
Configuration options for parameters affecting gate operation and speed.
Procedure for resetting the control unit to its default factory settings.
Detailed definitions and configurations for logic menu options.
Configuration details for safety inputs like photocells and safety edges.
Step-by-step guide on how to manually release and operate the gate actuator.
Important safety instructions for end-users to prevent injury and damage.
Guidelines for the proper disposal and recycling of the product and its components.
