MAIN MENU DISPLAY DESCRIPTION
PARAM (PARAMETERS SUB-MENU) Adjustment of all numerical values (torque, time, speed).
LOGIC (LOGIC SUB-MENU) Enabling and disabling of features.
RADIO (RADIO SUB-MENU) Adding and deleting of radio transmitters (remotes).
LANGUAGE Selection of menu language (ITA - Italian, FRA - French, ENG - English, ESP – Spanish)
DEFAULT Changes all Parameters, Logic and Language (Italian) settings to factory default.
AUTOSET Performs Automatic torque setting for the motors.
MAIN MENU DISPLAY DESCRIPTION DEFAULT
PARAM TCA 10
LOGIC M1 T 50
RADIO M2 T 50
LANGUAGE M1 T SLOW 45
DEFAULT M2 T SLOW 45
AUTOSET OPEN DELAY TIME 1.0
CLS DELAY TIME 1.0
M1 FAST TIME 15
M2 FAST TIME 15
SLOW SPEED 0
ZONE NOT USED
Timer to close - Range: 3-60 seconds.
Motor 1 torque - Range: 1-99%.
Motor 2 torque - Range: 1-99%. Default: 50
Motor 1 slowdown torque - Range: 1-99%.
Motor 2 slowdown torque - Range: 1-99%.
Motor 2 open delay time - Range: 1.0-10 seconds.
Motor 1 close delay time - Range: 1.0-10 seconds.
Motor 1 full speed run time - Range: 1.0-30 seconds.
Motor 2 full speed run time - Range: 1.0-30 seconds.
Slowdown speed - Range: 0=Disabled, 1=50%, 2=33%, 3=25%
MAIN MENU
PARAMETERS SUB-MENU
MAIN MENU
PARAM DISPLAY DESCRIPTION DEFAULT
LOGIC TCA Timer to close OFF
RADIO 3 STEP OFF
LANGUAGE IBL OPEN OFF
DEFAULT FAST CLS OFF
AUTOSET PHOTOC. OPEN OFF
TEST PHOT OFF
1 MOT ON OFF
BLOC PERSIST OFF
START-CLOSE OFF
FIXED CODE OFF
RADIO PROG ON
MASTER NOT USED
Instant reverse. Gate reverses with START input during close cycle.
Ignore START input during the opening cycle.
Fast closing. Gate inmediately starts to close after PHOTO is cleared.
Ignore PHOTO during the opening cycle.
Photo supervision. Enables input 19.
Single motor operation. Disables Motor 1.
Positive lock. Presses for .5 seconds on close physical stop.
Close input. Turns terminal 16 into CLOSE only input.
Fixed code. Disables the rolling code feature on the radio receiver.
Quick remote learning. Allows remotely setting receiver on learn mode.
LOGIC SUB-MENU
PROGRAMMING MENU REFERENCE
MAIN MENU
PARAM
LOGIC DISPLAY DESCRIPTION
RADIO ADD START
LANGUAGE READ
DEFAULT ERASE 64
AUTOSET RX CODE
Radio learn. Programs transmitters as START input.
Transmitter read. Displays information about transmitter signal.
Memory deletion. Deletes entire receiver memory.
Displays receiver code for advanced programming.
RADIO SUB-MENU
NAVIGATION
OK
BACK / EXIT DOWN UP SELECT
Press OK twice to enter to the programming MAIN MENU
To Previous Page
Loading...
Need help?
General
