BGW 8000 - Power Supply and Voltage Configuration; Mains Connection, Voltage Conversion, and Grounding

04000
POWER MAINS CONNECTIONS
The
unit should be plugged in only when it has been established that it is wired for
the correct power mains voltage and after all other connections have been made.
The mains (AC line) voltage is indicated on the serial number label on the rear of
the unit. Products supplied for use in the United States and Canada are factory
wired for 120 volts. Only the indicated mains voltage should be used. If the mains
voltage must be changed, see POWER MAINS VOLTAGE CONVERSION.
A molded,
parallel blade, U-ground plug is supplied. This connector is standard in
the United States and Canada. For use elsewhere, the plug must be replaced with
the correct connector. The color-code of the cord is as follows:
HI (switched Le$) - Brown (or Black)
LO
(neutral Leg) - Blue (or White)
EARTH (Chassis ground) -
Green with Yellow tracer (or Green)