Bialetti SUPER CF69 - Page 55

EN
55
B) Fill the tank with cold water up to the MAX level.
C) Press On/O button (4) to switch the machine on.
D) Make sure the machines does not contain any capsule. If needed,
open and close the lever (7).
E) Position a suitable cup on the apposite rack and start the cleaning
mode pressing the espresso coee push button (5) and the long
coee one (6) at the same time for 5 secs.
DURING CLEANING MODE, FOR ABOUT ONE MINUTE,
THE MACHINE DISPENSES WATER INTERMITTENTLY
IN ORDER TO CLEAN AND RINSE THE INNER CIRCUITS
OF THE MACHINE DEEPLY. AFTER ONE MINUTE,
DISPENSING IS CONTINUOUS AGAIN. DURING THIS
ENTIRE CYCLE, THE LIGHTS OF THE TWO POURING
PUSH BUTTONS AND THE LIGHT OF THE ON/OFF
BUTTON WILL BLINK IN GREEN.
F) Stop the cleaning mode by pressing one of the three buttons, when
water reaches about half of the tank capacity.
G) Let the descaling agent act for aprox.ly 15-20 minutes with the
machine o.
H) Switch the machine on and carry out again the operations described
in point E) until the tank is completely empty.
I) Leave the machine o for approx.ly 5 minutes.
J) Remove the tank and rinse it thoroughly with clean cold water.
K) Fill the tank with clean water up to the “MAX” level and insert it in
its seat.
L) Start the cleaning mode pressing the espresso coee push button
(5) and the long coee one (6) at the same time for 5 secs until
the tank is completely empty. If necessary, start the cleaning
mode several times (the machine features a safety system, which
interrupts dispensing automatically after having dispensed 0.7 l of
liquid consecutively).
M) Carry out the operations described in point L).
8. Maintenance