Biamp PMA 2000-DM User Manual

A: 9300 S.W. Gemini Drive Beaverton, OR 97008 USA W: www.biamp.com
Parlé
Video Display Mount Kit (PMA 2000-DM)
Installation Guide
ABOUT THIS KIT
The PMA 2000-DM kit mounts a Parlé 2000 series bar to an (X- or H-type)
VESA-mounted video display.
INSTALLATION CONSIDERATIONS
• This kit can be configured so the Parlé bar is above or below the display.
In most cases, this can be done without removing the display from the
VESA mount.
• Spring tension arms hold the bar against the video display. The brackets
and arms may be reconfigured depending on the size of the display, the
type of VESA mount, and the bar's position.
• Once the bar is mounted, the arms can be angled forward/backward for
better visibility or coverage.
• To use this kit, access to either the screws holding the VESA (X- or
H-type) mount to the display, or the vertical rails or U-channel on an
H-type VESA mounting system is necessary.
• Please read the initial pages of this guide to prepare for the installation,
and determine which configuration fits your appliction.
5) Low Prole VESA mounts -
Install spacers between VESA
mount and TV to provide space for
the kit arms. The bar can then be
mounted above or below the TV.
Note: Must be able to remove TV from
the VESA mount to install the spacers.
2) PMA Kit attached to an X-style
(or H-Style) VESA mount with the
bar above the display.
1) PMA Kit attached to an H-style
(or X-Style) VESA mount with the
bar below the display.
CONFIGURATION KEY
3) PMA Kit shown attached to an
the vertical rails of a VESA mount
with the bar under the display.
4) PMA Kit shown attached to an
the vertical rails of a VESA mount
with the bar above the display.
KIT CONTENTS / DETAILS
Hardware
Qty Description
4 M8 x 25 PH Screws
4 M8 x 30 PH Screws
4 M8 x 40 PH Screws
4 M8 x 45 PH Screws
4 Spacers
2 M6 x 12
Flat Head Screws
2 M6 Nuts
2 M8 Flat Washers
2 M5 x 8 PH Screws
Brackets
Spring
Arm
Spring
Mechanism
Crossbar
Traveler Arm
The pin keeps arm
extended during
installation of the bar
in an under-display
configuration.
Left Arm
Right Arm
Pin

Biamp PMA 2000-DM Specifications

General

Model	PMA 2000-DM
Manufacturer	Biamp
Type	Power Amplifier
Channels	2
Power Output	2000W
Frequency Response	20 Hz - 20 kHz
Signal-to-Noise Ratio	>100 dB
THD+N	<0.1%
Operating Temperature	0° C to 40° C
Input Impedance	20k Ohms
Height	3.5"
Input Voltage	100-240V AC
Dimensions	19" x 3.5" x 16.25" (483 mm x 89 mm x 413 mm)