BidetMate.com Info@BidetMate.com
120V
Air
temp
Water
temp
Seat
temp
※
When the product leaves the factory, the remote control and the product are connected, if the
remote control went failure, please re-connect the code as following methods.
1. Unplug the product's
plug, press the stop ket for
few seconds until the level
light is flickered.
Press the stop key
for few seconds
Level light
is flickered.
2. Plug the attaching plug
when the remote control get
closer to the product.
3. The level light stops
flickering, and then it is
lighted on.
All the level light (red)
is lighted on
4. At the time, the remote
control and product is
re-connected.
Stop Front Rear Dryer Flush
H/C
Massage
Nozzle
clean
Nozzle
forward
Water
pressure
Water
pressure
Nozzle
backward
Air
temp
Water
temp
Night
light
Seat
temp
Remote Control Pair Code:
Pull the plug off→Press the stop
button until the gear lights flicker
→Pull the plug in when the remote
controller near the product→The
gear lights stop flicking and keep
lighting→Successful.
1.Open the water supply angle valve to
maximum as shown in the figure.
2.Confirm various connecting parts are not
water leaking.
※
In case of water leaking, unfasten the nuts
again and install them again.
120V
120V
Testing the Product
(Checking the side panel buttons and remote conrtol)
Matching Your Remote Control Code
14
To Next Page
Loading...
