EasyManua.ls Logo

BIEMMEDUE GE 36 - User Manual

BIEMMEDUE GE 36
28 pages
Go to English
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
GENERATORE D'ARIA CALDA
GENERATEUR D'AIR CHAUD
WARMLUFTERZEUGER
SPACE HEATER
GENERADOR DE AIRE CALIENTE
ТЕПЛОВОЙ ГЕНЕРАТОР
EC/GE
EC 22 - EC 22 DV - EC 32 - EC 32 DV
GE 36 - GE 36 DV - GE 46 - GE 46 DV
L-L 101.02-BM
MANUALE D’USO E MANUTENZIONE
LIVRET D’ENTRETIEN
BEDIENUNGSANLEITUNG
INSTRUCTIONS MANUAL
MANUAL DE INSTRUCCIONES
РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ И ОБСЛУЖИВАНИЮ

Table of Contents

Questions and Answers

  • N
    Nicole HarrisAug 16, 2025
    What to do if my BIEMMEDUE GE 36 Heater fan starts and flame lights, generating fumes?
    • P
      Peter RiddleAug 16, 2025
      If the fan starts, the flame lights, and it generates fumes, there might be several causes: * Insufficient combustion air: Make sure the air inlet and outlet are free. * Excess combustion air: Check the position of the air regulation ring. * Fuel contaminated or contains water: Drain the fuel tank and load it with clean fuel. * Air leaks in the fuel circuit: Check the seals on the ducts and the diesel filter. * Excess fuel at the burner: Check the pump pressure.
  • J
    Jessica BoydAug 22, 2025
    Why my BIEMMEDUE GE 36 motor does not start and there is no ignition?
    • B
      brandon19Aug 22, 2025
      If the motor doesn't start and there is no ignition, it could be due to: * Wrong setting of room thermostat or other control: Check the correct setting of the heater control. If it's a thermostat, make sure the selected temperature is higher than the room temperature. * Defective thermostat or other control: Replace the control device.
  • T
    Tracy ChapmanAug 26, 2025
    What to do if my BIEMMEDUE GE 36 Heater does not stop?
    • G
      Gabrielle YoungAug 26, 2025
      If the heater does not stop, it could be due to a defective solenoid seal. Replace the complete solenoid to resolve this issue.
  • A
    Amanda OsborneAug 28, 2025
    What to do if the BIEMMEDUE GE 36 fan stops during start-up or heating?
    • S
      samueldunnAug 28, 2025
      If the fan stops during start-up or heating, consider the following potential issues: * Presence of flame before transformer ignites: Clean and eliminate diesel residue in the combustion chamber. * Defective photocell: Replace the photocell. * Defective electrical motor: Replace the electrical motor. * Defective electrical motor bearings: Replace the electrical motor bearings. * Burned out condenser: Replace the condenser. * Defective electric ignitor: Check the connection of H.T. wires to electrodes and transformer. * Defective flame control box: Replace the control box.
  • M
    Michelle AndersonSep 3, 2025
    What to do if the BIEMMEDUE GE 36 fan starts and flame lights, generating fumes?
    • L
      Lauren BakerSep 3, 2025
      If the fan starts, the flame lights, but it generates fumes, here are some possible causes and solutions: * **Insufficient combustion air:** Make sure the air inlet and outlet are free. * **Excess combustion air:** Check the position of the air regulation ring. * **Fuel contaminated or contains water:** Drain the fuel tank and load it with clean fuel. * **Air leaks in the fuel circuit:** Check the seals on the ducts and the diesel filter. * **Insufficient fuel at burner / Excess fuel at burner:** Check pump pressure.
  • J
    Jerry GeorgeSep 6, 2025
    What to do if the BIEMMEDUE GE 36 Heater fan does not start or stops during start-up or heating?
    • C
      Chad StephensSep 6, 2025
      If the fan doesn't start or stops, it could be due to several reasons: * **No electrical current:** Check the mains. * **Voltage below 175V:** The heater will restart automatically when the voltage exceeds 190 V. Check the supply voltage. * **Voltage above 265V:** The heater will restart automatically when the voltage is below 250 V. Check the supply voltage.
  • A
    andrew84Sep 9, 2025
    Why BIEMMEDUE Heater fan starts and flame lights, generating fumes?
    • S
      Shaun RhodesSep 9, 2025
      If your BIEMMEDUE Heater's fan starts and the flame lights, but it generates fumes, consider these possible causes: * **Insufficient combustion air:** Ensure that both the air inlet and outlet are unobstructed. * **Excess combustion air:** Check the position of the air regulation ring. * **Fuel contaminated or contains water:** Drain the fuel tank and refill it with clean fuel. * **Air leaks in fuel circuit:** Inspect the seals on the ducts and the diesel filter. * **Insufficient fuel at burner/Excess fuel at burner:** Check pump pressure.
  • R
    rebeccamillerSep 10, 2025
    What to do if my BIEMMEDUE GE 36 fan does not start or stops during start-up or heating?
    • C
      Craig PalmerSep 12, 2025
      If the fan doesn't start or stops during start-up or heating, here are a few things to check: * No electrical current: Check the mains. * Voltage below 175V: The heater will restart automatically when the voltage exceeds 190 V. * Voltage above 265V: The heater will restart automatically when the voltage is below 250 V.
  • W
    williambennettDec 1, 2025
    Why does the BIEMMEDUE GE 36 Heater fan stop during start-up or heating?
    • M
      Mary WatersDec 1, 2025
      The fan might stop during start-up or heating due to: 1. Presence of flame before the transformer ignites: Clean and eliminate diesel residue in the combustion chamber. 2. A defective photocell: Replace the photocell. 3. A defective electrical motor: Replace the electrical motor. 4. Defective electrical motor bearings: Replace the electrical motor bearings. 5. A burned-out condenser: Replace the condenser. 6. A defective electric ignitor: Check the connection of H.T. wires to electrodes and transformer. 7. A defective flame control box: Replace the control box. 8. Insufficient or no fuel at burner: Check the state of the motor-pump plastic coupling. 9. Defective solenoid or electric ignitor: Check the electrical connection. 10. Internal error of electronic device: Reset the devic...

BIEMMEDUE GE 36 Specifications

General IconGeneral
BrandBIEMMEDUE
ModelGE 36
CategoryHeater
LanguageEnglish

Related product manuals