What to do if my BIG ASS FANS powerfoil x2.0 will not start?
If your BIG ASS FANS Fan isn't starting, check these things: Ensure all wires are securely connected. Confirm the wall controller is set to RUN and LOC mode. Check that the power supply is adequate and functional. If it still doesn't start, further assistance may be needed.
Why is my BIG ASS FANS powerfoil x2.0 wobbling during operation?
If your BIG ASS FANS Fan is wobbling, verify that the mounting structure is rigid enough to support the fan and that the fan is not being exposed to external air forces. If guy wires were installed, confirm proper installation.
How to fix a popping noise coming from my BIG ASS FANS powerfoil x2.0 Fan?
A popping noise may be due to loose airfoils. To resolve this, first disconnect the fan from power. Then, tighten the airfoil hardware to a torque of 29 ft·lb (39.3 N·m). If the popping continues, check if the airfoils are touching each other.
How to stop radio frequency noise (RF) from my BIG ASS FANS Fan controller?
Fan controllers can generate RF noise. To minimize this, do not run your controller and sensitive equipment on the same power line. Also, ensure proper grounding at the motor, controller, and from the controller to the utility.
What to do if my BIG ASS FANS Fan is turning in the wrong direction?
For effective operation, your BIG ASS FANS Fan should rotate counterclockwise when viewed from the floor. If it's not, simply press the FWD/REV button on the wall controller to change the direction.
Why does my BIG ASS FANS powerfoil x2.0 motor make noise when the speed is increased?
Audible high frequency carrier noise may indicate a stall condition. Verify motor currents are within limits. See the fan specifications.
General| Brand | BIG ASS FANS |
|---|---|
| Model | powerfoil x2.0 |
| Category | Fan |
| Language | English |
Technical specifications for the Powerfoil X2.0 fan, including size, motor, and voltage.
Technical specifications for the Powerfoil X2.0 Plus fan, detailing various sizes and electrical requirements.
Guidelines for site preparation, including mechanical and electrical considerations and safety clearances.
Instructions for securing the upper yoke to an I-beam, detailing hardware and bolt torque.
Guide to selecting appropriate angle iron dimensions based on span for bar joist mounting.
Steps for pre-drilling angle irons to ensure correct hole placement for mounting.
Procedure for connecting the extension tube to the upper yoke, ensuring correct orientation.
Instructions for correctly installing the safety cable as a critical safety feature.
Steps for selecting a location and mounting the VFD enclosure.
Explains error codes and procedures for resetting the fan controller.
Accessing and modifying controller parameters, with cautions for authorized personnel.
Steps to lock or unlock the wall controller keypad to prevent unauthorized changes.
Annual checklist of critical inspection and maintenance tasks for fan safety and longevity.
Common fan issues and their potential solutions before contacting support.
Specific error codes for E Series controllers and corrective actions.
Specific error codes for M Series controllers and their corrective actions.
NFPA 13 compliance requirements for HVLS fans in sprinklered buildings, including specific fan placement.
To Next Page