BIG RED JACKS SJ10 - Owner and User Responsibility; Read Manual Before Operation

2
IMPORTANT
OWNER / USER RESPONSIBILITY
INTENDED USE
TECHNICAL SPECIFICATIONS
Before You Begin Register This Product.
For future reference, record the model name, model number, date of manufacture and purchase date of this
product. You can nd this information on the product.
Model Name
Model Number
Date of Manufacture
Date of Purchase
DO NOT OPERATE OR REPAIR THIS PRODUCT WITHOUT READING THIS MANUAL.
Read and follow the safety instructions. Keep Instructions readily available for operators. Make certain all
operators are properly trained and understand how to safely and correctly operate the product. By proceeding
you agree that you fully understand and comprehend the full contents of this manual. Failure to operate this
product as intended may cause injury or death. The manufacturer is not responsible for any damages or injury
caused by improper use or neglect. Allow product operation only with all parts in place and operating safely.
Use only genuine replacement parts. Service and maintain the product only with authorized or approved
replacement parts; negligence will make the product unsafe for use and will void the warranty. Carefully
inspect the product on a regular basis and perform all maintenance as required. Store these instructions
in a protected dry location. Keep all decals on the product clean and visible. Do not modify and/or use for
any application other than that for which this product was designed. If you have any questions relative to a
particular application, DO NOT use the product until you have rst contacted the distributor or manufacturer to
determine if it can or should be performed on the product.
For technical questions please call 1-888-448-6746.
Screw jacks lift and precisely position a variety of loads. Upright or inverted, these jacks operate at full
capacity in tension or compression. Mechanical jacks offer increased precision and travel speed required
to level or lift loads needing rigorous detail or load stabilization. Use this jack on house leveling, bridge
stabilization, machinery, oil field maintenance or steel fabrication and construction. Can also be used as
an external locking device to hold position. Multi-axis, cleated saddle positions accommodate and assist in
leveling the load. This product is tested for reliability and safety to meet ASME B30.1 Standards.
Item Capacity
Bar Hole
Size
Min.
Height
Lifting
Range
Max.
Height
Net
Weight
SJ05 5 TON 9/16 inch 9-1/2 inch 3-7/8 inch 13-3/8 inch 9.25 lbs.
SJ10 10 TON 11/16 inch 11-1/2 inch 6-5/16 inch 17-13/16 inch 16 lbs.
SJ15 15 TON 13/16 inch 14 inch 7-7/16 inch 21-7/8 inch 23.13 lbs.
SJ20 20 TON 1 inch 15-13/16 inch 9-1/16 inch 24-7/8 inch 34 lbs.
SJ25 25 TON 1 inch 16-3/4 inch 9-3/4 inch 25-1/2 inch 40.31 lbs.
____________________________
____________________________
____________________________
____________________________